In this episode we are going to look at Use LLDP to Map a Network. A senior network administrator requires us to map the Remote Branch Office network and discover information about all of the devices in the network. We must record all of the network device names, IP addresses and subnet masks, and physical interfaces interconnecting the network devices. To map the network, we will use SSH for remote access and the Link Layer Discovery Protocol (LLDP) to discover information about neighboring network devices. Because LLDP is a Layer 2 protocol, it can be used to discover information about devices that do not have Layer 3 connectivity. We will record the information that we gather to complete the Addressing Table and provide a topology diagram of the Remote Branch Office network. We will be Mapping a network using LLDP and SSH remote access. Thank you so much for listening to this episode of my series on Enterprise Networking, Security, and Automation for the Cisco Certified Network Associate (CCNA). Once again, I’m Kevin and this is KevTechify. Let’s get this adventure started. All my details and contact information can be found on my website, https://KevTechify.com ------------------------------------------------------- Cisco Certified Network Associate (CCNA) Configuration Examples for Enterprise Networking, Security, and Automation v3 (ENSA) Network Management Lab 10.2.6 - Use LLDP to Map a Network Podcast Number: 82 Season: 1 ------------------------------------------------------- Equipment I like. Home Lab ►► https://kit.co/KevTechify/home-lab Networking Tools ►► https://kit.co/KevTechify/networking-tools Studio Equipment ►► https://kit.co/KevTechify/studio-equipment