Brians Questions: Does a combination square needs to be a Starrett ($$$$) or we clan go with cheaper brands. Kind regards from São Paulo - Brazil. Hey guys, quick question for you. I have an old grizzly 20" planer and I want to resaw some wood on my bandsaw down to 1/2" and 1/4" pieces. The bandsaw is from 1943 and doesn't leave the best finish. The minimum thickness on the planer is 1/2" but I see the piece do some shimmying when I put stock that thin through there. What's the best way to finish planing the stock and finishing it off without access to a drum sander? Any tips would be much appreciated. Love the show and keep up the good work! JARED Guy's Questions: Hey guys. I have been wanting to ask this for a while now. I have been asked by my wife to build dresser for our bedroom. This would be my first time building drawers. I have the cabinet built and the drawer boxes built. But when I put the slides on the drawers just don’t glide like I would think they would. I mean some of them do. I am just not sure what I am doing wrong. I have checked all my spacing for the openings. Could it be my boxes are not square? What is the best way to get them square? Nick. I've been listening for a few years now, and have learned a lot. My most pressing question is about finishing. Recently l've built a couple kitchen tables that I really wanted to be special and put a lot of time into them. I thought everything turned out great, but at the final step, topcoating, I got a lot of streaking - more so than I've gotten before (although this is a bigger surface area project than I've ever done). I stained it, then used AquaCoat water-based grain filler (which left a few minor streaks across the grain that I couldn't sand out, but I can live with that), and then 3 coats of ArmRSeal satin. After the 3rd coat I had a dull sheen in one spot and so gave it a 4th coat of satin, pretty thick this time, and the sheen streaking got worse. Am assuming that I need to sand it down (and hopefully not get down into the stain) and start again. Someone suggested gloss or semi-gloss ArmRSeal and then a final coat with satin. Is there an easier solution - buff it out?? Mark Schmidt Huy's Questions:  Hello gentlemen. I stumbled across your podcast a few months ago and have been enjoying it ever since. I apologize I have not spent a lot of time going back through older episodes, so this question may have come up already. I’ve been woodworking as a hobby for several years now and enjoy it as my creative outlet. I prefer making smaller pieces as opposed to big furniture but have dabbled with both as gifts and favors to friends. In 2023 I’d like to start turning this into a small business. I enjoy my day job, so this would be more of a side hustle to make enough money to buy more wood and tools (and maybe whiskey 😉). Do you have any tips or tricks for getting started selling projects? Facebook marketplace seems like a dead zone and Etsy seems saturated. Thanks, and I appreciate any advice you have on this subject. Nick Hellman I am slowly trying to turn my tiny shed into a shop. It is coming along but is not climate controlled. I was recently glueing up some thin strips of wood for an accent on a holiday gift. I live in Oregon, about an hour east of Portland. It doesn’t get super cold here usually, but that week was a bit colder than usual. Anyway, when I went to trim up the strips they came apart where they were glued up. The glue didn’t bond at all. There was just white remnants of dry glue. After asking a friend who is a professional woodworker and reading the label I learned that you can’t use wood glue below 46°. The bottle says not to let it freeze. My friend told me once the bottle freezes it is not good anymore. I bought a new bottle and am keeping it inside the house and doing glue ups inside until the spring. Is this true that once the bottle freezes it’s no good? Any advice for working in the winter in an unheated shop? Should I